
Model: ABC31SM
For charging standby & on-line batteries
The new Three-Phase Automatic Battery Charger features a switch-mode design for high efficiency. The unit also features:
- AC voltage compensation
- DC voltage regulation
- Full current limit
- Filtered DC output
Three rate charging is standard. The charger will raise the voltage to the high rate setting and maintain this level for a timed interval at which point it will reduce to a safe float. Recharge of the battery is accomplished without excessive over or under charging.
The ABC-series chargers are fully current limited. If current demands exceeds the chargers rating, the output voltage drops rapidly, protecting the charger and the system to which it is connected. The chargers fuses or breakers will not trip during such overload conditions.
Request More Information
STANDARD FEATURES
Conservative component selection and design assures long life
LEDs for AC-ON
AC and DC surge protection
DC voltmeter & ammeter 2%
Precise voltage regulation
Fully current limited
AC input and DC output fuses
Reverse battery protection
Forced air cooling, fans temperature and load controlled
Modular construction
OPTIONS
AC and DC 2-pole breakers
Precision metering
Battery temperature compensation
AC failure alarm relay
DC Failure Alarm Relay
Multi-Alarm Monitor includes four alarms & LEDs with common relay High DC volts, Low DC volts, Rectifier failure and Ground fault.
Audible alarm
Drip Shields
CE compliance and marking
INPUT
Voltage: 480V AC +/-15%
Phase: Three
Frequency: 50 or 60 Hertz
OUTPUT
Voltage: 24 to 120V DC
Current: From 20 to 240 amps
Regulation: +/- 1/2% from no load to full load,
with +/- 15% AC line variation
Output Ripple: <1%
4X battery connected
Efficiency: Up to 93%
OPERATING TEMPERATURE
From -4oF (-20oC) to +122oF (+50oC)
PROTECTION
AC input fuse or optional breaker
DC output fuse or optional breaker
Automatic current limiting
AC surge suppressor
Slow start circuitry
Reverse battery protection
VENTILATION
Forced Air Cooling
CABINETS
ANSI #61 light gray powder coat
14/18 guage steel
Wall or floor mounting
STANDARD DISPLAYS
AC-ON LED
DC voltmeter and ammeter -2% accuracy
DIMENSIONS SPECIFICATIONS All dimensions in inches.
CASE SIZE W4
Height 36
Width 16
Depth 16